Chdc Configuration - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Radio>  <802.11a/n/ac> or <802.11b/g/n>  <RRM> menu in the sub-menus.
Enable or disable the DCS in the SERVICE field in Dynamic Channel Selection.
7.4.4

CHDC Configuration

This section describes the setting options of the CHDC function which adjusts the Tx
Power when Coverage Hole occurs.
Configuration using CLI
1) Go to configure  rrm configuration mode of CLI.
WEC8500# configure terminal
WEC8500/configure# rrm
2) Go to the wireless section where you want to change the settings.
WEC8500/configure/rrm# 80211a
3) Set the CHDC function. Enter the chdc setting mode and enable it Use the 'no'
parameter to disable the mode. The function operates only when the RRM is enabled.
WEC8500/configure/rrm/80211a# chdc
WEC8500/configure/rrm/80211a/chdc# enable
4) To use the pre-alarm function, operator can collect the statistics from an AP.
After entering into the chdc configuration mode, complete configuration
(statsCollectEnable). To disable the configuration, enter the 'no' parameter. All the
functions for pre-alarm are available only when both RRM and CHDC are enabled.
Samsung Electronics America
Figure 138. DCS settings
Version 5.2
page 275 of 533