Samsung WEC8500 Operation Manual page 136

Controller
Hide thumbs Also See for WEC8500:
Table of Contents

Advertisement

WEC8500/8050 Operation Manual
Parameter
PORT
FALLBACK START-
END TIME
INTERVAL
3) Enter into the configure  AP configuration mode of CLI and configure a primary,
secondary, and tertiary server. To make an AP operate in redundancy configuration,
configure the Discovery of the AP as 'apc-referal'.
WEC8500# configure terminal
WEC8500/configure# ap ap_1
WEC8500/configure/ap ap_1#
discovery apc-referal
primary-apc [APC_NAME]
secondary-apc [APC_NAME]
tertiary-apc [APC_NAME]
Parameter
APC_NAME
DISCOVERY_TYPE
Samsung Electronics America
CAPWAP PORT number of the APC to add
This port number is required by an AP to connect to the APC. If no port
number is entered, it is set to 5246, the default port number of CAPWAP
protocol. It is recommended not to use a different port number if it is
specially required.
Enter the time zone where an AP connected to the backup (secondary or
tertiary) APC can do fallback.
The input format is as follows:
- Format: hh:mm-hh:mm
- Example: 2:00-5:00  Fallback is available between 2pm and 5pm.
Configures the interval that an AP connected to the backup (secondary or
tertiary) APC attempts fallback (second).
If a specific time is not entered, the default is 120 seconds.
The minimum is 60 seconds and the maximum is 1800 seconds.
Enter the name of an APC registered to redundancy.
- Primary apc: The first APC that the AP attempts to connect.
It is usually configured with the currently connected APC.
- Secondary-apc, tertiary-apc: APC that the AP attempts to connect when
there is no response from the primary-apc.
Discovery Type
- ap-followed: Discovery type is set by AP.
- apc-referal: Discovery type is set by APC using the backup APC lists.
To apply the priority of APC to which the AP will be connected, operator
needs to select the apc-referal.
- DHCP: Discovery type is interoperating with the DHCP server. To use this
mode, IP ADDRESS POLICY of the AP must be set to DHCP.
- Auto: Discovery type is automatically changed by the AP for automatic
connection to the APC.
Description
Description
Version 5.2
page 136 of 533

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wec8050

Table of Contents