Qos Configuration Of Ap - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
6.2.2

QoS Configuration of AP

6.2.2.1 Wire Section
The APC provides QoS in a wire section using 802.1p and Differentiated Services Code
Point (DSCP) marking and it can adjust packet traffics because it can adjust queue length
depending on packet type.
Configuration using CLI
To configure the Station QoS parameter that will be applied to the wire section between
APC and AP, execute the command as follows:
1) Go to configure  QoS mode of a wireless section of CLI.
APC# configure terminal
APC/configure# [80211a/80211bg] qos
APC/configure/80211a/qos#
2) Configure a QoS policy to a wire section packet.

802.1P Policy: enable policy [802_1P]

DSCP Policy: enable policy [DSCP_OUTER] [DSCP_INNER]
Parameter
enable
802_1P
DSCP_OUTER
DSCP_INNER
3) Configure a default 802.1p value per packet.

dot1p-tag [PACKET_TYPE] [802.1P_TAG]
Parameter
PACKET_TYPE
802.1P_TAG
Samsung Electronics America
Enables 802.1p or DSCP marking.
802.1p configuration (user_priority/default)
- user_priority: Marks the 802.1p or User Priority value of an incoming
packet into the 802.1p field.
- default: Marks pre-configured basic value to the 802.1p field.
DSCP Outer configuration (inner_packet/default)
- inner_packet: Marks the DSCP value of an incoming packet into the
Outer DSCP field.
- default: Marks pre-configured basic value to the Outer DSCP field.
DSCP Inner configuration (no_mark/default)
- no_mark: Marks no value into the Inner DSCP field.
- default: Marks pre-configured basic value to the Inner DSCP field.
Packet type configuration (voice/video/best_effort/background)
Default 802.1p value
Description
Description
Version 5.2
page 246 of 533