Samsung WEC8500 Operation Manual page 153

WEC8500/8050 Operation Manual
scan-time-channel
scan-time-interleave
start
scan-time-service
STA's scanning
scan-trigger-level
start
target-ap
<cr>
WEC8500/configure/ap-group default/airmove# enable ?
<cr>
WEC8500/configure/ap-group default/airmove# decision-delta ?
1 - 100
WEC8500/configure/ap-group default/airmove# number-of-channel ?
1 - 20
WEC8500/configure/ap-group default/airmove# number-of-proreq ?
1 - 10
WEC8500/configure/ap-group default/airmove# scan-time-channel ?
0 - 100
WEC8500/configure/ap-group default/airmove# scan-time-interleave ?
1000 - 10000
WEC8500/configure/ap-group default/airmove# scan-time-service ?
1 - 1000
WEC8500/configure/ap-group default/airmove# scan-trigger-level ?
-128 - 0
WEC8500/configure/ap-group default/airmove# target-ap ?
all
keep-ap-config
WEC8500/configure/ap-group default/airmove# end
4) Use the 'show airmove group [ap_group_name]' command to check the AP group
information.
WEC8500# show airmove group default
Airmove Group Configurations
----------------------------
Airmove State
Target AP
Scan trigger level
Scanning time for one channel
Samsung Electronics America
Set time required for one channel scanning
Set interval time required for new scanning
Set time required for STA service during
Set a trigger level for STA's scanning
Set config target ap
Enter the value [dBm]
Enter the number
Enter the number
Enter the time [ms]
Enter the time [ms]
Enter the time [ms]
Enter the trigger level [dBm]
All
Keep ap config
Disable
Keep Ap Config
-70 dBm
5 ms
Version 5.2
page 153 of 533