Policy-Map Configuration - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
3.5.3

Policy-map Configuration

1) Go to the fqm mode to configure the configure  ACL rule of CLI.
APC# configure terminal
APC/configure# fqm-mode
2) Go to policy-map mode. To delete a policy map, enter 'no' parameter in front of the
command.

policy-map [POLICY_MAP_NAME]

no policy-map [POLICY_MAP_NAME]
3) By using the class name configured in the class-map, go to the input mode.

class [CLASSMAP_NAME]
4) Configure a policy-map using the following command.
[Bandwidth to a class of traffic]

bandwidth percentage [PERCENTAGE_VALUE]
[Configure set action]

mark cos [COS_VALUE]

mark ip dscp [DSCP_VALUE]

mark ip precedence [PRECEDENCE_VALUE]

mark priority [PRIORITY_VALUE]
[Configure police action]

police trtcm cir [1-1000] cbs [125000-125000000] pir [1-1000] pbs [125000-
125000000] conform-action(drop|(dscp [0-63]|ip [0-7])|transmit) exceed-
action(drop|(dscp [0-63]|ip [0-7])|transmit) violate-action(drop|(dscp [0-63]|ip [0-
7])|transmit)(color-aware|color-blind|)
[Peak rate to a class of traffic]

queue-limit [QUEUE_NUM]
[Peak rate to a class of traffic]

shape-peak [PEAK_RATE]
5) Exit the policy-map mode.

exit
6) To check the configuration information, use the 'show running-config network'
command.
Samsung Electronics America
Version 5.2
page 114 of 533