Samsung WEC8500 Operation Manual page 288

WEC8500/8050 Operation Manual
[Enable/Disable Spectrum]
The command that enables or disables the spectrum analysis function is shown below.

service [MODE]
Parameter
MODE
[Spectrum Analysis Report Configuration]
The command used to enable or disable each spectrum analysis data item is shown below.

configuration-request [DATA] [MODE]
Parameter
DATA
MODE
[Channel Report Interval Configuration]
The command is shown below.

channel-interval [INTERVAL]
Parameter
INTERVAL
[Changing Channel]
By using the following command, you can change a channel for which the spectrum
analysis will be executed.
(The default is 'All' channels.)

dot11b: 2.4 GHz wireless bandwidth

dot11aLow: 5 GHz low wireless bandwidth

dot11aMid: 5 GHz mid wireless bandwidth

dot11aHigh: 5 GHz high wireless bandwidth
Samsung Electronics America
Enables or disables spectrum analysis
- enable: Enable (default)
- disable: Disable
Type of a report to configure (sample/duty-cycle/interference)
- sample: FFT report (default: disabled)
- duty-cycle: Duty cycle report (default: disabled)
- interference: Interference report (default: enable)
Enables or disables each report function.
- enable: Enable
- disable: Disable
Channel report interval (range: 1000-60000 ms, default: 1000)
Description
Description
Description
Version 5.2
page 288 of 533