Samsung WEC8500 Operation Manual page 152

WEC8500/8050 Operation Manual
Parameter
LED-CONFIG
OVERWRITE-VLAN
VLAN-SUPPORT
NATIVE-VLANID
5) Use the 'show ap-group detail [AP_GROUP_NAME]' command to check the AP
group information.
Configuring AirMove Service of AP Group with CLI
1) Go to configure mode of CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create an AP group or enter the AP group configuration mode.

ap-group [AP_GROUP_NAME]
3) Enter the profile configuration mode for the AP group.

profile
4) Configure the AirMove service of the AP group.

enable: Enables/disables the AirMove service.

target-ap: This option is used for selecting APs which will be applied with the
changes made to the group settings. If 'all' is selected, changes are applied to all APs
and config priority of the APs also change to group. If 'keep-ap-config' is selected,
only the APs whose config priority is set to group have the airmove value of the
group applied to them.
WEC8500# configure terminal
WEC8500/configure# ap-group default
GroupName : default
WEC8500/configure/ap-group default# airmove
WEC8500/configure/ap-group default/airmove# ?
decision-delta
enable
exit
number-of-channel
one time scanning
number-of-proreq
during one time scanning
Samsung Electronics America
group are applied to all APs within the group.
This configures whether to turn the LED on/off.
If overwrite-vlan is enabled, the VLAN settings of the AP group
are applied to all APs within the group.
This configures whether to enable the native VLAN of the AP.
This configures the native VLAN value of the AP.
Set delta value for handover decision
Airmove enable
Exit from airmove mode
Set the number of channel required during
Set the number of probe request required
Description
Version 5.2
page 152 of 533