Configuring Remote Ap Group - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
4.2.2

Configuring Remote AP Group

If the APs are located in an area where the APC is not located, those APs must be classified
into a separate group for service. The APC can manage the APs in another area by grouping
them into a remote AP group.
In the Remote AP group menu, operator can configure the below information and the APs
in the Remote AP group are operating based on the same configuration.

Remote AP Addition/Removal
 APs can be added to/removed from a remote AP group.

Local Authentication
 Radius Server
The Radius server which authenticates stations accessing the remote AP can be
configured.
 Remote AP User List
Users (stations) to be managed by the remote AP can be added/removed.
If an AP is added to or deleted from a remote AP group, the AP is rebooted and reconnected
to the APC. If an AP moves between remote AP groups, the AP is not rebooted.
If an AP is added to a remote AP group, the WLAN and default configuration of AP is not
changed from the policy configured in the AP group.
4.2.2.1 Addition/Removal Setting
Configuration using CLI
1) Go to configure mode of CLI.
WEC8500# configure terminal
WEC8500/configure#
2) Create or delete a remote AP group. To delete a remote AP group, enter 'no' parameter
in front of the command

remote-ap-group [REMOTE_AP_GROUP_NAME]

no remote-ap-group [REMOTE_AP_GROUP_NAME]
Samsung Electronics America
Version 5.2
page 155 of 533