Figure 195. Telnet/Ssh Server Configuration - Samsung WEC8500 Operation Manual

WEC8500/8050 Operation Manual
[Checking Server Configuration Status]
To check the status of telnet or ssh server, enter the following command. You can retrieve
the configured port number as well as server status.

show ssh-server: Retrieves the status of SSH server

show telnet-server: Retrieves the status of telnet server
[Using as Client]
By using the APC as a telnet or SSH client, you can connect to a server.
Enter as follows in CLI.

telnet [IP_ADDRESS] [PORT_NUMBER]

ssh [IP_ADDRESS] [ID] [PORT_NUMBER]
Parameter
IP_ADDRESS
ID
PORT_NUMBER
Configuration using Web UI
To configure the Telnet/SSH server configuration, in the menu bar of <WEC Main
window>, select <Administrator> and then select the <Telnet-SSH> menu in the sub-
menus.
You can configure the service by using the Enable/Disable radio box of 'TELNET
SERVICE' or 'SSH SERVICE'.
You can configure the port number of service by using 'TELNET PORT' or 'SSH PORT'.
By using 'SESSION TIMEOUT', you can configure the session timeout of TELNET or
SSH in min. and can also configure maximum number of sessions by using 'MAXIMUM
NUMBER OF SESSIONS'.
Samsung Electronics America
IP address or domain name of a server to connect
login ID
Port number (range: 1-65535)
If the port number is not entered, its default is shown below.
- telnet: 23
- ssh: 22

Figure 195. Telnet/SSH server configuration

Description
page 374 of 533
Version 5.2