Samsung WEC8500 Operation Manual page 78

WEC8500/8050 Operation Manual
3.4.5.5 Network Configuration
Configuration using CLI
Go to configure  ospf configuration mode of CLI.
WEC8500/configure/router/ospf 2# ?
area
auto-cost
to bandwidth
capability
compatible
default-information
information
default-metric
distance
distribute-list
exit
host
max-concurrent-dd
concurrently
maximum-area
neighbor
network
ospf
overflow
passive-interface
redistribute
routing protocol
router-id
summary-address
timers
WEC8500/configure/router/ospf 2# network ?
A.B.C.D
A.B.C.D/M
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <Network>  <OSPF>  <Network> menu in the sub-menus.
The OSPF initial window is shown below.
Samsung Electronics America
OSPF area parameters
Calculate OSPF interface cost according
Enable specific OSPF feature
OSPF compatibility list
Control distribution of default
Set metric of redistributed routes
Define an administrative distance
Filter networks in routing updates
Exit from router mode
OSPF stub host entry
Maximum number allowed to process DD
Maximum number of ospf area
Specify a neighbor router
Enable routing on an IP network
OSPF specific commands
Control overflow
Suppress routing updates on an interface
Redistribute information from another
Router-id for the OSPF process
Configure IP address summaries
Adjust routing timers
Network number
OSPF network prefix
Version 5.2
page 78 of 533