Samsung WEC8500 Operation Manual page 171

WEC8500/8050 Operation Manual
4.2.4.5 AP SNMP Agent Configuration
The APC operator can configure SNMP Agent settings for all APs.
Configuration using CLI
Execute the following commands to configure the SNMP Agent settings of the AP.
1) Go to configure  snmp  ap mode of CLI.
WEC8500# configure terminal
WEC8500/configure# snmp
WEC8500/configure/snmp# ap
WEC8500/configure/snmp/ap#
2) Configure the snap agent information of the AP.
Enable/disable SNMP of the AP.

enable or no enable
Configure the SNMP port number of the AP.

Port [PORT NUMBER]
Configure the Read Only Community Name of the AP.

ro-community [COMMUNITY NAME]
Configure the Write Only Community Name of the AP.

rw-community [COMMUNITY NAME]
Configure the user information of the AP.

Use r[USER NAME] [AUTHENTICATION TYPE] [AUTHENTICATION KEY]
[PRIVATE PROTOCOL] [PRIVATE KEY]
Parameter
PORT NUMBER
COMMUNITY NAME
USER NAME
AUTHENTICATION TYPE
AUTHENTICATION KEY
PRIVATE PROTOCOL
Samsung Electronics America
This is the SNMP port number.
This is the SNMP Read Only or Write Only Community name.
This is the SNMP user name.
This is the SNMP authentication type. Either of the following two
can be selected:
- MD5
- SHA
A number in the range of 8 to 20 can be entered.
Either of the following two can be selected:
- DES
- AES
Description
Version 5.2
page 171 of 533