Selecting The Calibrate Laminator Tab - HID HDP5000 User Manual

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
• Do not show this message again. The check box allows the user to suppress the
message per Driver instance. Default = unchecked.
3.2.5 Using the Clean Printer message
The default setting is checked. If checked, a clean printer message displays after 3000 prints.
3.2.6 Using the Error Status message
The default setting is checked. If checked, error messages (with solutions) display when an
error occurs.
3.2.7 Using the Password Prompt message
The default setting is checked.
• If checked, a dialog message requests a password to continue printing.
• Password protection is set and activated in the Workbench.
3.2.8 Selecting the Display Language
There are two areas where you change interface languages, the workstations Driver software
and the printer display.
Select the Driver software language when installing the driver. For changing the Driver
software language after the initial installation, use the Toolbox.
The default printer language is English. By sending a language pack file to the printer, the
printer is capable of other languages. Change the printer language by using the Toolbox
(once sending the proper language pack to the printer). Only the languages available within
the printer firmware (as downloaded through the language packs) are choices in the dropdown
menu. Contact Technical Support to obtain printer language packs.
3.3

Selecting the Calibrate Laminator tab

The Calibrate Laminator tab is active when the Laminator is detected automatically or
manually selected (Printer Feature from the Configuration tab). If the Laminator is not
detected, the tab is active; however, functions are grayed out.
• Calibrate button: Sends calibrate Laminator command to Printer. Follow the
instructions to set up the Printer.
• Help button: Launches help specific to this tab.
Step Procedure
Select the Calibrate Laminator tab.
1
a. Ensure that the Cartridges are out of the Laminator.
b. Ensure the Laminator Cover is closed.
Click Calibrate.
c.
Note: The Printer's LCD will display CALIBRATE PASSED. Error Message Calibration Failed may
be solved by manually increasing the sensor calibration number to 13 of higher under the
Advanced Settings tab. Do not use the AUTO calibrate function.
d. Click OK on the LCD display to complete the procedure.
July 2013
© 2012, 2013 HID Global Corporation. All rights reserved.
Page 19 of 101