Page 4-3
4.2
Calibrate Laminator Tab
The Calibrate Laminator tab is active when the laminator is automatically detected or when
the laminator is manually checked as a feature on the Configuration tab.
Note: The lamination module must be warm before calibrating. Calibration may also be performed
from the printer LCD. See Section 3.10.2: Sensor Calibration Options.
To Calibrate the Laminator:
1.
Ensure that the cartridges are out of the Laminator.
2. Ensure the Laminator cover is closed.
3. Click Calibrate.
November 2015
ToolBox
PLT-02496, Version: 1.0