Workbench Printer Utility; Access The Workbench Printer Utility - HID HDP5000 User Manual

Step Procedure
5 If the tape test indicates inadequate adhesion, increase the heat setting by 5 degrees, print another
card and try the tape test again.
• Once the temperature has been increased 4 times (20 degrees), reset temperature to default and
increase the Dwell Time by .5 second.
• Repeat this process until adequate adhesion is achieved.
• Ensure that the cards (in use) have a surface roughness (Ra) of 60 micro inches or less.
This information should be available from the card manufacturer.
7

Workbench Printer Utility

See the Workbench Printer Utility Help for additional information.
7.1

Access the Workbench Printer Utility

Click Diagnostics to access the Workbench Printer Utility.
The Workbench Printer Utility displays. Find the Workbench Printer Utility User Guide on your
CD.
Page 84 of 101
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
© 2012, 2013 HID Global Corporation. All rights reserved
July 2013