Figure 6 - Print Top Of Form - HID HDP5000 User Manual

3.7.4 Print Top of Form
From Advanced Settings, modify the Print Top of Form Setting.

Figure 6 - Print Top of Form

Step Procedure
1 Verify the Transfer TOF is set to +35.
2 Verify the Print TOF is set to +20.
3 Verify the Print LOF is set to +7.
4 Print the alignment card self-test (the front edge should look like the figure).
5 Adjust the Print TOF until the green border is eliminated and the entire Transfer Alignment Block is
shown in the center of the card.
Note:
Due to variation in roller alignment, the green border may appear at a slight angle on the top of
the card.
6 Verify the entire alignment block is visible and the green has been eliminated from the center of the
card.
Page 26 of 101
HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
© 2012, 2013 HID Global Corporation. All rights reserved
July 2013