C50 Card Printer User Guide, Part Number PLT-01277, Rev 1.1
4.5
Using the Calibrate Ribbon tab
Calibrate Ribbon enables the Operator to start the ribbon calibration.
Figure 4 - Calibrate Ribbon
Step
Procedure
1
Remove the ribbon cartridge.
2
Close the printer's cover.
3
Click Calibrate. The printer's buttons blink in an alternating sequence during the calibration
process. The printer beeps twice to indicate successful completion. The printer beeps once
to indicate unsuccessful completion.
4.6
Using the Clean Printer tab
To clean the printer, follow the instructions outlined on the Clean Printer tab. You can perform
additional cleaning as needed (see Cleaning).
Page 21
© 2013 HID Global Corporation /ASSA ABLOY AB. All rights reserved.
June 2013