Figure 10 - Ribbon Print Supply Tension - HID HDP5000 User Manual

HDP5000 & HDPii Plus Card Printer Encoder User Guide_L000950, 3.0
3.7.9 Transfer Temp Offset
This option adds an offset to the printer temperature of the transfer roller.
Note: Use this setting only for making the temperature of the transfer roller and the LCD goal
match.
Use the Image Transfer tab slider to make adjustments for card stock.
•
• A negative (-) adjustment increases the actual roller temperature.
3.7.10 Print Flip Angle
Use the Print Flip Angle option to set the position of the flipper so it is level with the card path
after a flip operation.
3.7.11 Encoder Flip Angle
Use the Encoder Flip Angle option to fine-tune the position of the flipper.
Note: This setting is in relation to the printer's built-in encoder if your printer is equipped with
this option.
3.7.12 Print Flip Level
Use the Print Flip Level option to set the position of the flipper so it is level with the card path.
3.7.13 Ribbon Print Takeup Tension
Use the Ribbon Print Takeup Tension to set the tension of the color Ribbon during printing.
Adjust the Ribbon tension if the Ribbon wrinkle is appearing on the card.
Note: Adjustments moderately change the image length.
3.7.14 Using the Ribbon Print Supply Tension Setting
This procedure controls the tension of the color Ribbon during printing. Adjust the Ribbon
tension if the Ribbon wrinkle is appearing on the card.
Note: Adjustments moderately change the image length. "+" Adjustments can eliminate some
cases of wrinkle.

Figure 10 - Ribbon Print Supply Tension

July 2013
© 2012, 2013 HID Global Corporation. All rights reserved.
Page 29 of 101