6: Network Settings; Network 1 (Eth0) Interface Settings; Table 6-1 Network Interface Settings - Lantronix PremierWave XC HSPA+ User Manual

6: Network Settings
The Network Settings show the status of the Ethernet interface/link and let you configure the
settings on the device. Interface settings are related to the configuration of the IP and related
protocols. Link settings are related to the physical link connection, which carries the IP traffic.
The PremierWave contains one network interface. The Ethernet interface is also called interface 1
or eth0.
Notes:
Some settings require a reboot to take effect. These settings are noted below.

Wait a minimum of 10-20 seconds after rebooting the unit before attempting to make

any subsequent connections.
The blue text

user-specified name.

Network 1 (eth0) Interface Settings

Table 6-1 shows the network interface settings that can be configured.
Network Interface
Settings
State
BOOTP Client
DHCP Client
Priority
IP Address
PremierWave XC HSPA+ User Guide
PRELIMINARY DRAFT
in the XML command strings of this chapter are to be replaced with a

Table 6-1 Network Interface Settings

Description
Select to enable or disable the interface.
Select to turn On or Off. At boot up, after the physical link is up, the
PremierWave will attempt to obtain IP settings from a BOOTP server.
Note: Overrides the configured IP address/mask, gateway, hostname, and
domain. When DHCP is Enabled, the system automatically uses DHCP,
regardless of whether BOOTP is Enabled. Changing this value requires you to
reboot the device.
Select to turn On or Off. At boot up, after the physical link is up, the
PremierWave will attempt to obtain IP settings from a DHCP server and will
periodically renew these settings with the server.
Note: Overrides BOOTP, the configured IP address/mask, gateway,
hostname, and domain. Changing this value requires you to reboot the device.
Note: Within WebManager, click Renew to renew the DHCP lease.
It ranges from 0-10. Note: Lower priority number means higher preference.
Enter the static IP address to use for the interface. You may enter it alone or in
CIDR format.
Note: This setting will be used if Static IP is active (both DHCP and BOOTP
are Disabled). Changing this value requires you to reboot the device. When
DHCP or BOOTP is enabled, the PremierWave tries to obtain an IP address
from a DHCP or BOOTP server. If it cannot, the PremierWave generates and
uses an Auto IP address in the range of 169.254.xxx.xxx, with a network mask
of 255.255.0.0.
PRELIMINARY DRAFT
32