Host Configuration
Host Settings
Name
Protocol
SSH Username
Remote Address
Remote Port
To Configure Host Settings
Note:
The following section describes the steps to view and configure Host 1 settings;
these steps apply to other host instances of the device.
Using Web Manager
To configure a particular Host, click Host on the menu and select Host 1 -> Configuration.
Using the CLI
To enter the Host command level: enable -> config -> host 1
Using XML
Include in your file:
PremierWave XC HSPA+ User Guide
PRELIMINARY DRAFT
Table 10-2 Host Configuration
Description
Enter a name for the host. This name appears on the Login Connect
Menu. To leave a host out of the menu, leave this field blank.
Select the protocol to use to connect to the host. Choices are:
Telnet
SSH
Note:
SSH keys must be loaded or created on the SSH page for the
SSH protocol to work.
Appears if you selected SSH as the protocol. Enter a username to
select a pre-configured Username/Password/Key (configured on the
SSH: Client Users page), or leave it blank to be prompted for a
username and password at connect time.
Enter an IP address for the host to which the device will connect.
Enter the port on the host to which the device will connect.
<configgroup name="host" instance="1">
PRELIMINARY DRAFT
10: Terminal and Host Settings
58
Need help?
Do you have a question about the PremierWave XC HSPA+ and is the answer not in the manual?