Opening The Plc Basic Program System Library - Siemens SINUMERIK 840D sl Configuration Manual

3.2

Opening the PLC basic program system library

Procedure
Proceed as follows to open and display the system library of the PLC basic program:
1. Switch to the "Libraries" task card.
2. Select the PLC basic program that matches the firmware version of the inserted NCU:
– SINUMERIK 840D sl PLC basic program V4.5.x.x
– SINUMERIK 840D sl PLC basic program V4.7.x.x
– SINUMERIK 840D sl PLC basic program V4.8.x.x
Result
The system library of the PLC basic program has been opened. Information on handling can
be found under Using copy templates (Page 48) and Adding the PLC basic program
(Page 60).
Further information
The block descriptions and other information about the PLC basic program are contained in
the P3 section of the SINUMERIK 840D sl Basic Functions Manual. Basic PLC program.
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017
3.2 Opening the PLC basic program system library
Programming the PLC
59