Siemens SINUMERIK 840D sl Configuration Manual page 193

The Safety Administration Editor is divided into the following sections:
● General
● F-runtime groups
● F-blocks
● Access protection
● Settings
F-libraries
You can not only store F-blocks in global libraries and project libraries as master copies, but
also use them as already tested and approved safety functions.
However, you must observe additional conditions, which are described in the following help
functions:
Help on SIMATIC Safety, Section "Acceptance of the system"
TIA Portal online help, Section "Libraries"
Reserved block numbers for SINUMERIK Safety Integrated plus (F-PLC)
An F-runtime group is created when you activate Safety Integrated plus (F-PLC) mode. An
associated F-FB, F-FC and F-DB is created in the reserved number range for F-runtime
groups:
Reserved number range for F-runtime groups
● F-FB 1010..1019
● F-FC 1010..1019
● F-DB 1010..1019
Further reserved number range for F-runtime groups
● F-FB: 3999..7999
● F-FC: 3999..7999
● F-DB: 8000..16000
See also: Creating a second F-runtime group for Safety Integrated plus (F-PLC) (Page 196)
Further information
Detailed information on the Safety Administration Editor can be found in the Programming
and Operating Manual SIMATIC Safety – Configuring and Programming, or in the section
with the same name in the TIA Portal online help.
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325
9.8 Configuring Safety Integrated plus (F-PLC)
Safety configuration
193