Exporting Plc Symbols - Siemens SINUMERIK 840D sl Configuration Manual

Sinumerik step 7 toolbox v14 sp1
Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Programming the PLC
3.10 Exporting PLC symbols for SINUMERIK Operate
3.10.2

Exporting PLC symbols

Note
Deleting unwanted blocks before exporting PLC symbols
If you have saved unwanted blocks in your project, this lengthens the time required for
exporting and importing PLC symbols.
Consequently, delete unwanted blocks that you copied previously from the basic program
library prior to the export.
See: General information about the PLC program (Page 45)
Requirement
● The software has been compiled completely.
● The associated languages are activated as project languages in the TIA Portal.
See: Information system, "Activate project languages" section
Note
Comments only in German or English
Because SINUMERIK Operate can manage only German and English comments, you
can export only German and English comments from the TIA Portal.
● The PLC symbols to be exported are valid.
Note
Only valid PLC symbols are exported
The following PLC symbols are not taken into account during the export:
• PLC symbols of know-how-protected blocks
• PLC symbols of F-blocks
• Internal PLC symbols
• Invalid/faulty PLC symbols
74
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents