2.2
Insert NX module
Procedure
In order to insert an NX module into the project via the hardware catalog, proceed as follows:
1. In the network view, navigate in the hardware catalog to the folder "Controller >
SINUMERIK 840D sl > NX" and select, for example, NX15.3 .
2. You can select the firmware version of the NX module at "Information" in the hardware
catalog. This must match the firmware version of the NCU. Firmware versions of the
configured hardware and the real hardware must match.
3. Use drag-and-drop to move the NX module from the hardware catalog to the network
view.
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325
Configuring the NCU
2.2 Insert NX module
21