Illustra IPS02D0OCWTT Configuration And User's Manual page 95

Backup/Restore
The Choose file to Upload dialog will be displayed.
4 Navigate to the location where the firmware file has been saved.
5 Select the firmware file then select the Open button.
6 Select Upload.
The file transfer will begin. Do not disconnect power to the camera during the upgrade process. The
camera restarts automatically after the updates have been completed, this can take from 1 to 10
minutes.
The Log in page will be displayed.
Refer to Procedure 3-1 Log in to the Camera on page 3-10 to log back into the camera Web User
Interface.
Backup/Restore
Backup camera data and restore from a previously saved data file. The data file can be saved to a specified
location and used to restore the camera configuration.
Note:
A saved backup data file created on a camera is camera specific and cannot be used to restore the settings on a
different camera.
Procedure 10-4 Backup Camera Data
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Backup/Restore tab.
4 Select Backup.
You will be prompted to save the backup file.
5 Select Save.
Procedure 10-5 Restore Camera from Backup
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select the Backup/Restore tab.
4 Select Browse.
95
- End -
- End -