Table of Contents
Advertisement
TCP/IP
DHCP
On initial camera startup, and after a hardware factory reset, Dynamic Host Configuration Protocol (DHCP) is
enabled by default and remains enabled until the camera receives either a DHCP address or is assigned a Static
IP address.
Procedure 3-1 Enable DHCP
Step Action
1
Select Setup on the Web User Interface banner to display the setup menus.
2
Select the TCP/IP tab in the Basic Configuration menu.
3
Select the Enable DHCP check box to enable DHCP and disable manual settings.
4
Select Apply to save the settings.
The camera will search for a DHCP server. If one is found it will connect to that server. f no connection is
made to a DHCP server within two minutes, the camera goes to the default IP address 192.168.1.168,
but continues to search for a DHCP address.
Note:
If the camera is assigned a Static IP address prior to DHCP being enabled, the camera first reboots for
approximately 30 seconds and then remains accessible at its Static IP until a connection is made to a
DHCP server.
Procedure 3-2 Disable DHCP
Step Action
1
Select Setup on the Web User Interface banner to display the setup menus.
2
Select the TCP/IP tab in the Basic Configuration menu.
Clear the Enable DHCP check box to disable DHCP and allow manual settings to be entered.
The default setting is 'Enabled'.
3
If Enable DHCP has been disabled:
a
Enter the IPv4 Address in the IPv4 Address text box in the form xxx.xxx.xxx.xxx.
The default setting is '192.168.1.168'
b
Enter the Network Mask in the Network Mask text box xxx.xxx.xxx.xxx.
The default setting is '255.255.255.0'
c
Enter the Gateway IP address in Gateway text box xxx.xxx.xxx.xxx.
d
Enter the Primary DNS Server in the Primary DNS Server text box xxx.xxx.xxx.xxx.
4
Select Apply to save the settings.
14
- End -
- End -
Hide quick links:
Advertisement
Table of Contents
