Illustra IPS02D0OCWTT Configuration And User's Manual page 106

Record Settings
2 Remove the SD card from the camera.
Note:
AVI clips are not available on the camera until the MicroSD card has been inserted and the camera
rebooted.
3 Reconnect the power supply and power up the camera.
Procedure 11-4 Unmount the MicroSD Card for Removal
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select SD Card Management menu from the Edge Recording menu.
3 Select Unmount.
You are prompted to confirm the unmounting.
4 Select OK to confirm.
OR
5 Select Cancel.
Remove the SD card from the camera.
AVI clips are not available on the camera until the SD card has been inserted and mounted.
Record Settings
Select which video stream to use for alarm video and configure pre and post event durations for the playable video
clip. The camera can record video generated from MD, face detection and DIO events.
Procedure 11-5 Configure Record Settings
Step Action
1 Select Setup on the Web User Interface Banner to display the setup menus.
2 Select Record Settings from the Edge Recording menu.
3 Select Enable Record to allow the camera to create a playable video clip.
OR
Deselect Enable Record to disable the feature.
4 If Enable Record has been enabled:
a Select the required video stream from the Video drop-down menu.
Refer to Procedure 5-1 Configure the Video Stream Settings.
106
- End -
- End -