Illustra IPS02D0OCWTT Configuration And User's Manual page 94

Maintenance
Reboot
To perform a physical reboot of the camera, refer to Procedure 17-1 Reboot the camera using the Reboot/Reset
Switch on page 17-154.
Procedure 10-2 Reboot the Camera
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select Reboot.
You will be prompted to confirm the camera reboot.
4 Select OK to confirm.
The Web User Interface will display a "Camera Rebooting" page with a progress bar showing the reboot
progress.
When the camera is restarted it will take 2 - 3 minutes until it is online and ready to be accessed and
controlled.
OR
Select Cancel.
5 The Log in page will be displayed.
Camera Firmware Upgrade
The camera can be upgraded using firmware provided by Illustra. Alternatively, the camera can also be upgraded
using Illustra Connect. Refer to the Illustra Connect User Guide for further information.
Note:
All existing camera settings are maintained when the firmware is upgraded.
Caution
You should only use firmware that has been provided by Illustra. Using any other firmware may cause a
malfunction and damage the camera.
Procedure 10-3 Upgrade Camera Firmware
Step Action
1 Select Setup on the Web User Interface banner to display the setup menus.
2 Select Maintenance from the System menu.
3 Select Browse.
94
- End -