Brake Light Switch/Starting Inhibitor; Switch - TGB 525 Service Manual

Brake Lining Wear
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
● To check front brake lining must be remove
front wheel first.
● It is not necessary to remove brake hose when
replacing the brake lining.
Brake Lining Replacement (refer chapter
14)
Make sure the brake lining condition.
Replace the lining if the brake lining wear limitation
groove close to the brake disc.
Caution
● Do not operate the brake lever after the clipper
removed to avoid clipping the brake lining.
● In order to maintain brake power balance, the
brake lining must be replaced with one set.

Brake Light Switch/Starting Inhibitor

Switch

The brake light switch is to light up brake light as
brake applied.
Make sure that electrical starter can be operated
only under brake applying.
PDF created with pdfFactory Pro trial version
To this chapter contents
2. MAINTENANCE INFORMATION
Front brake
Brake lining wear
limitation groove
Rear brake
Brake lining wear
limitation groove
Brake switch
www.pdffactory.com
Lining
Brake disk
Brake switch
2-9