Enable Use Of Bit-Type Fan Speed Objects (For Control); Enable Use Of Bit-Type Fan Speed Objects (For Status) - IntesisBox DK-RC-KNX-1i User Manual

®
IntesisBox KNX - Daikin A.C. (SKY & VRV line)
 DPT type for +/- Fan Speed Object
This parameter lets choose between the datapoints 0-Up / 1-Down [DPT_1.008]
and 0-Decrease / 1-Increase [DPT_1.007] for the Control_ Fan Speed +/- object.
 Roll-over Speed at upper/lower limit
This parameter lets choose if roll-over will be enabled ("yes") or disabled ("no") for
the Control_ Fan Speed +/- object.

4.4.4 Enable use of bit-type Fan Speed objects (for Control)

This parameter shows/hides the bit-type Control_ Fan Speed objects.
If set to "no" the objects will not be shown.
o
If set to "yes" the Control_ Fan Speed objects for Speed 1, Speed 2 and Speed 3 (if
o
available) will appear. To activate a Fan Speed by using these objects a "1" value has to
be sent.

4.4.5 Enable use of bit-type Fan Speed objects (for Status)

This parameter shows/hides the bit-type Status_ Fan Speed objects.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
Figure 4.14 Parameter detail
Only if Roll-over is enabled
Fan Speed 1
Only if Roll-over is enabled
Fan Speed 2

Up / Increase

Down / Decrease
User's manual r1.0 eng
Fan Speed 3
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
26 / 66