Enable Use Of Bit-Type Vane U-D Objects (For Control); Enable Use Of Bit-Type Vane U-D Objects (For Status) - IntesisBox DK-RC-KNX-1i User Manual

®
IntesisBox KNX - Daikin A.C. (SKY & VRV line)
This parameter lets you choose if SWING function is included ("yes") or not ("no")
in the sequence when using Control_ Vane Up-Down +/- object as shown in the
discontinuous segment at the picture below.
 Rollover Vane at upper/lower limit
This parameter lets choose if roll-over will be enabled ("yes") or disabled ("no") for
the Vane Up-Down +/- object.
Pos. 1

4.5.5 Enable use of bit-type Vane U-D objects (for Control)

This parameter shows/hides the bit-type Control_ Vane Up-Down objects.
If set to "no" the objects will not be shown.
o
If set to "yes" the Control_ Vane Up-Down objects for each Position (1 to 5) will appear.
o
To activate a Vane Position by using these objects, a "1" value has to be sent.

4.5.6 Enable use of bit-type Vane U-D objects (for Status)

This parameter shows/hides the bit-type Status_ Vane Up-Down objects.
If set to "no" the objects will not be shown.
o
If set to "yes" the Status_ Vane Up-Down objects for each Position (1 to 5) will appear.
o
When a Vane Position is enabled, a "1" value is returned through its bit-type object.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
Only if Roll-over is enabled
Pos. 2 Pos. 3
Only if Roll-over is enabled

Up / Increase

Down / Decrease
User's manual r1.0 eng
Pos. 4 Pos. 5
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
SWING
31 / 66