Enable "Fan Speed Manual/Auto" Objects (For Control And Status); Enable Use Of Bit-Type Fan Speed Objects (For Control) - IntesisBox ME-AC-KNX-1i User Manual

KNX – Mitsubishi Electric A.C.
®
IntesisBox
➢ DPT type for +/- Fan Speed Object
This parameter lets choose between the datapoints 0-Up / 1-Down [DPT_1.008]
and 0-Decrease / 1-Increase [DPT_1.007] for the Control_ Fan Speed +/-
object.
➢ Does +/- sequence include fan speed AUTO?
This parameter lets choose if AUTO function is included ("yes") or not ("no") in the
sequence when using Control_ Fan Speed +/- object as shown in the discontinuous
segment at the picture below.
➢ Roll-over Speed at upper/lower limit
This parameter lets choose if roll-over will be enabled ("yes") or disabled ("no") for
the Control_ Fan Speed +/- object.

4.4.6 Enable "Fan Speed Manual/Auto" objects (for Control and Status)

This parameter shows/hides the bit-type Control_ Fan Speed Manual/Auto objects.
If set to "no" the Control_ Fan Speed Manual/Auto communication objects will not be
o
shown.
If set to "yes" the Control_ Fan Speed Manual/Auto communication objects will appear.
o

4.4.7 Enable use of bit-type Fan Speed objects (for Control)

This parameter shows/hides the bit-type Control_ Fan Speed objects.
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SLU
Only if Roll-over is enabled
AUTO*
FS 1
Only if Roll-over is enabled
▪
▪
*
FS 2 FS 3*
Up / Increase
Down / Decrease
If Available
URL
Email
tel
User's manual r2.3 eng
FS 4*
http://www.intesisbox.com
info@intesisbox.com
+34 938047134
24 / 63