IntesisBox DK-RC-KNX-1i User Manual page 43

®
IntesisBox KNX - Daikin A.C. (SKY & VRV line)
This parameter lets you choose how much time to wait (in minutes) before executing
the action specified in the next parameter ("Action after timeout elapsed").
 Action after timeout elapsed
When Switch-Off is selected, once the timeout has elapsed, the indoor unit will be
turned off.
When Apply Preset Delta is selected, once the timeout has elapsed, a delta
temperature will be applied in order to save energy (decreasing the setpoint when in
Heat mode, or increasing the setpoint when in Cool mode). Also new parameters will
appear.
 Temp delta decrease (HEAT) or increase (COOL) (ºC)
This parameter lets configure the delta temperature (increase or decrease) that
will be applied when the timeout has elapsed.
Important: When there is occupancy again after the application of a delta, the
same delta will be applied inversely. (i.e. In a room with AC in cool mode and
25ºC setpoint temperature, a +2ºC delta is applied after the occupancy
timeout, setting the setpoint at 27ºC because there is no occupancy in the
room. If the setpoint is raised to 29ºC during that period, when the room is
occupied again, a -2ºC delta will be applied and the final setpoint temperature
will then be 27ºC).
 Enable secondary timeout
If set to "no" nothing will be applied.
If set to "yes", a new timeout will be enabled and two new parameters will
appear.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
Figure 4.34 Parameter detail
Figure 4.35 Parameter detail
User's manual r1.0 eng
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
43 / 66