Enable Use Of Power Mode - IntesisBox DK-RC-KNX-1i User Manual

®
IntesisBox KNX - Daikin A.C. (SKY & VRV line)
The Special Modes can be parameterized through the ETS parameters dialog, and they can
be used to give extra functionality.
Important: When executing any of the Special Modes, the real state of the indoor unit
will NOT be shown in KNX.
Important: When the predefined time for the Special Mode is finished or a "0" value is
sent to stop it. The previous state will be recovered.
Important: If a value concerning On/Off, Mode, Fan Speed or Setpoint Temperature is
received from KNX while any Special Mode is running ("1"), the Special Mode will stop
and the previous state will be recovered. The value received will be also applied then.
Important: If a value concerning On/Off, Mode, Fan Speed or Setpoint Temperature is
modified through the remote controller, the Special Mode will stop WITHOUT recovering
the previous state. Then the real indoor unit state will be shown in KNX including the new
value received through the remote controller.

4.3.1 Enable use of POWER mode

This parameter shows/hides the Control_ Start Power Mode and Status_ Power Mode
communication objects. The Power Mode lets change the Setpoint Temperature and the Fan
Speed within a given period of time.
If set to "no" the objects will not be shown.
o
If set to "yes" the Control_ Start Power Mode and Status_ Power Mode objects and new
o
parameters will appear.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
Figure 4.10 Default Special Modes Configuration dialog
User's manual r1.0 eng
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
19 / 66