Enable Use Of Sleep Timeout - IntesisBox DK-RC-KNX-1i User Manual

®
IntesisBox KNX - Daikin A.C. (SKY & VRV line)
 If a "1" value is sent to the Control_ Occupancy object after the timeout period,
the indoor unit will turn on.
 If a "0" value is sent to the Control_ Occupancy after the timeout period no
action will be performed.

4.8.3 Enable use of SLEEP timeout

This parameter shows/hides the Control_ Start Sleep Timeout communication object which
lets you start a timeout to automatically turn off the indoor unit.
If set to "no" the object will not be shown.
o
If set to "yes" the Control_ Start Sleep Timeout object and a new parameter will appear.
o
If a "1" value is sent to this object the switch-off timeout will begin. If a "0" value is sent
to this object, the switch-off timeout will stop.
 Timeout to apply action (minutes)
This parameter lets you select how much time (in minutes) to wait before switching
off the AC unit.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
Figure 4.37 Parameter detail
User's manual r1.0 eng
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
45 / 66