IntesisBox DK-RC-KNX-1i User Manual page 44

®
IntesisBox KNX - Daikin A.C. (SKY & VRV line)
 Timeout to apply action (minutes)
 Action after timeout elapsed
 Disallow On/Off operation while not Occupied
If set to "no", On/Off commands while the window is open will be accepted.
 If a "1" value is sent to the Control_ Occupancy object the switch-off timeout
period will begin again.
 If a "0" value is sent to the Control_ Occupancy object, no action will be
performed.
If set to "yes", On/Off commands while not occupied will be saved (but not applied).
These commands will be used in the next parameter if set to "yes".
 Reload last On/Off value when Occupied
If set to "no", once the switch-off timeout has elapsed, any value will be reloaded.
If set to "yes", once the switch-off timeout has elapsed, the last On/Off value will be
reloaded.
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
®
IntesisBox is a registered trademark of Intesis Software SL
This parameter lets you choose how much time to wait (in minutes)
before executing the action specified in the next parameter ("Action after
timeout elapsed").
When Switch-Off is selected, once the timeouthas elapsed, the indoor
unit will turn off.
When Apply Preset Delta is selected, once the timeout configured is
extinguished, a delta temperature will be applied (decreasing the
setpoint when in Heat mode, or increasing the setpoint when in Cool
mode). Also new parameters will appear.
 Temp delta decrease (HEAT) or increase (COOL) (ºC)
This parameter lets configure the delta temperature that will be
applied when the timeout is extinguished.
Important: When there is occupancy again after the application
of a delta, the same delta will be applied inversely as explained
above.
Figure 4.36 Parameter detail
User's manual r1.0 eng
URL http://www.intesis.com
Email info@intesis.com
tel +34 938047134
44 / 66