Axia Element Installation & User Manual page 23

which can operate
remote producer's panel. It also mutes CR moni-
tors when
On.
is used for any other guest mic in the
CR Guest
»
control room. Its associated logic port mutes the
CR monitors when
headphone feed.
is used for any mic located in a
» Studio Guest
separate studio. Its logic mutes the Studio moni-
tors when . It can have an individual head-
On
phone feed.
is used for any line input audio source, ana-
Line
»
log or digital. A GPIO logic port can be used to
provide machine start/stop pulses if desired.
defines this source as a hybrid or broad-
Phone
»
cast phone system input. Summed mono mix-mi-
nus provided.
marks this source as a codec. Dual-mono
Codec
»
mix-minus provided; one PA feed + one talent
feed with talkback.
Computer Player
»
nating from a PC. Associated GPIO logic can be
used to send start/stop signals to a playout sys-
tem.
About Telos Phone System Modes: Telos
TWOx12, Nx12 and Series 2101 broadast phone
systems work in two different modes: US Mode
and Euro Mode.
In US Mode, one of the phone system's hy-
brids is assigned to a console faders, and tak-
ing a caller to air is accomplished by using a
switching control to select a line on that hybrid
and turning its fader ON.
In Euro Mode, the swiching control is not used;
instead, each line from the phone system is per-
manently assigned to a separate fader, which
may be turned ON or OFF at will.
Element supports both US and Euro modes. The
next few settings are used for setting up the
desired style of phone operation.
The next 4 options are used for EURO mode only:
• PHONE HYBRID IP:
TWOx12, Series 2101 or Telos TWO and you will be
operating in Euro mode, enter the IP address of the
phone system.
functions from a
Talk to...
. It can have an individual
On
defines this source as origi-
If this source is a Telos Nx12,
©2008 Axia Audio — Rev. 3.0
Figure 2-1: Source Profile options (yes, there are a lot!)