Table of Contents
Advertisement
Individual Headphones Section
Note: These controls apply ONLY IF:
• The loaded source is a Mic-type source.
• The loaded source has an individual head-
phone feed associated with it.
• The position at which the mic is installed also
has an Element accessory panel that allows tal-
ent to select their own headphone feeds (such
as the one shown in Figure 5-2).
The source currently specified
•
CURRENT SOURCE:
for monitoring in the Monitors page of
the Show Profile.
•
SOURCE FOR PRESET 1:
source that will load when the acces-
sory panel's
key is pressed.
Ext 1
•
SOURCE FOR PRESET 2:
source that will load when the acces-
sory panel's
key is pressed.
Ext 2
•
HEADPHONES MASTER GAIN:
ify the initial amount of gain that the
Individual Headphone Feed will have
when the Show Profile loads. Turn then
or
up to 85 dB of cut.
Off
Use
Finishing Up...
Finally, there are two more controls at
the very bottom of the screen:
button applies any changes made
•
SAVE CHANGES
to the current Channel Description. If you don't click
this button, your changes won't be saved!
•
BACK TO SHOW PROFILE
the Show Profile Settings menu.
The Auxiliary Send And Return
Description Screen
In the same way that the Show Profile Channel De-
scription screens mirror Element's
Specify the
Specify the
Spec-
Figure 5-2: an
Element accessory
panel with headphone
selector
link takes you back to
Channel Options
©2008 Axia Audio — Rev. 3.0
menus, the Auxiliary Send Description Screen captures
the global Aux Send settings that can be set using the
Global Options Sends & Returns Key
Master Module.
Note: Instead of the Retain Source Settings
option found in the Channel Descriptions pages,
the Auxiliary Send Descriptions Screen features
a new option: Retain Existing Settings. Us-
ing this option with any of the Aux Send/Return
settings allows the Show Profile to be loaded
without disturbing the Aux Send/Return master
settings in use by the board operator.
From the Show Profile Settings web
page, choose the Auxiliary Send/Return
Data link. You'll find the following op-
tions:
•
Aux Send A / B / C / D Master Gain:
Selecting
Off
ment for each
Select
and enter a gain value between
Use
-25 dB and 10 db to trim overall gain if de-
sired, or select
•
Aux Send A / B / C / D On/Off Sta-
Choose
tus:
Send 1 off completely,
Retain Existing Setting.
•
Aux Return 1 /2 Master Gain:
ing
turns off master gain adjustment
Off
for the selected Aux Return bus. Select
and enter a gain value between -25 dB and 10
Use
db to trim overall return gain if desired, or select
Retain Existing Setting.
•
Aux Return 1 / 2 On/Off Status:
turn the selected Aux Return off completely,
turn it on, or
Retain Existing Setting.
•
Aux Return 1 / 2 Signal Mode:
(left channel fed to both sides),
Stereo, Left
(right channel fed to both sides),
mono and feed to both sides) or
Setting.
located on the
turns off master gain adjust-
outbound feed.
Aux Send's
Retain Existing Setting.
to turn the selected Aux
Off
to turn it on, or
On
Select-
Choose
Off
On
Choose from
Right
(sum L+R to
Sum
Retain Existing
to
to
Advertisement
Table of Contents
