Axia Element Installation & User Manual page 149

the connector socket. This will eject the connector.
Figure C-9: Location of alpha display ribbon connectors as
seen from rear of overbridge
Note: Ribbon connectors must be connected
to the alphanumeric panels "tail-down", that is,
with the ribbon emerging from the bottom of
the connector.
You may now slide the disconnected alpha panels
out of the overbridge mounting channel, along with the
blanking panel occupying your new display's position.
Carefully slide your new alphanumeric panel into the
mounting channel. Note that the metal portion of the dis-
play has rounded edges which fit into the round frontmo-
st channel; the circuit-board portion of the display must
have its top and bottom edges located in teh first groove
behind the round channel.
Figure C-10: Detail of overbridge mounting channel
After all of the overbridge panels have been located
in the mounting channel, reconnect their ribbon cables.
Connect the ribbon cable that came with your new dis-
play, and thread it from the overbridge into the "bucket"
through the passage provided.
Re-mount the endpanel, taking care to locate the
overbridge hinge pin in the hole provided.
Now, connect the RJ45 patch cable supplied in your
module kit to any free jack on Element's connection pan-
el, located in the center of the overbridge compartment.
Note: You've probably noticed that 4-space El-
ement modules have two RJ45 connectors on
their undersides. These are "daisy chain" con-
nectors; in the event that all of the jacks on your
Element's connection panel are in use, you can
connect a new module to the unused jack on
any other module.
Connect the other end of the patch cable to the RHJ45
connector located on the bottom of your new module,
connect the alpha display ribbon connector.
Note: Ribbon connectors must be connected to
the modules "tail-up", with the cable emerging
from the connector toward the top of the mod-
ule.
Your new module should look as shown in Figure C-
11. Once all cables are connected, seat the module in the
frame and secure it with the provided 2.5 mm hex-head
screws(s).
Figure C-11: Reverse view of connected module. Note
ribbon cable is connected "tail-up".
Replace any other modules you may have removed,
and secure them as well.
The final step in the module installation process is to
"capture" the new console configuration. To enter Cap-
©2008 Axia Audio — Rev. 3.0