Table of Contents
Advertisement
these settings.
»
Rotate the
HP LINK
the headphone source will follow the Monitor
1 source selection. Push the knob to
selection.
*
means that Headphone and Monitor
Linked
1 selections will mirror each other; making a
selecton from one bank of keys on the Moni-
tor Module will automatically choose the
same source on the other bank.
*
allows Monitor 1 and Headphone
Unlinked
sources to be selected independently of each
other.
»
The
knob allows the board op to turn
H/P PROC
Headphone Processing on and off, define how it
operates if active, and change Headphone Process-
ing settings. Pushing the
onscreen and takes the operator
Change Settings
to the
screen shown in Figure 4-15.
H/P Process
In this screen, the operator is presented with
a graphical representation of the EQ curve ap-
plied to the headphone channel. Talent can then
Figure 4-15: H/P Process settings.
knob to choose whether
your
Take
knob selects
HP Proc
©2008 Axia Audio — Rev. 3.0
apply three-band parametric equalization to his
or her headphone channel, and select headphone
dynamics processing. The screen indicates the
amount of cut/boost applied, and the center fre-
quency of each band as well as a list of Omnia
processing presets.
»
Lo Gain/Bypass/Active:
Knob adjusts the amount of gain or cut applied
to the low EQ band. Pressing this knob toggles
EQ between
and
Active
EQ mode for this band automatically changes
to Peak mode when boost is applied, and Shelf
mode when cut is applied.
*
Rotating the
Lo Freq
frequency of the low EQ band (20 - 320 Hz).
*
Rotating the
Mid Gain
Knobs adjust gain and center frequencies of
the midrange EQ band (125 Hz - 2 kHz).
*
The
knob adjusts the boost/cut of the
Hi Gain
high frequency band (1.25 kHz - 20 kHz).
*
Hi Freq/Shelf/Peak:
Knob adjusts the center frequency of the high
EQ band (1 kHz - 16 kHz). Pushing this knob
toggles the high-band EQ method between
and
modes.
Peak
Shelf
*
Press the
Monitor Options
the previous menu.
Note: High, Mid and Low band adjustments
provide up to 25 dB of cut and 15 dB of boost.
Element EQ features SmartQ™ automatic band-
width system that varies the Q of the selected
parametric band to provide the most pleasing
EQ effect. For details on SmartQ, please refer
to Page 44 of this manual.
»
The
knob controls whether audio
H/P PREV
from the
bus can be fed to the board
Preview
op's headphones, and if so, in what manner. Note
that operators can also press the
key on Element's Monitor Module to toggle
HP
through these settings. Rotating this knob selects
from the following options:
*
The operator will not hear Preview au-
Off:
dio in the headphone channel.
*
audio from the Preview channel over-
On:
Rotating this Soft-
Note that the
Bypass.
knob adjusts the center
and
Soft-
Mid Freq
Rotating this Soft-
key to return to
Preview to
Advertisement
Table of Contents
