Axia Element Installation & User Manual page 61

left/right), (left source channel fed to L/R
Left
input), (right source channel fed to L/R
Right
input) and (left and right source channels
Sum
summed to mono and fed to L/R input). Push to
the new setting.
Take
: If the selected source is stereo, rotat-
Phase
»
ing this control lets the board op compensate for
out-of-phase audio sources.
in-phase sources;
Inv Left
the left input channel only,
phase of the right input channel only, and
reverses phase of both stereo channels.
Both
If the selected source is in mono, the choices are
and
Normal Invert
setting.
»
Pressing
Pan & Mode
nel Options screen.
» Aux Sends Key
Element has four stereo Aux buses that can be used
as utility buses for mixing, for constructing custom IFB
mixes, or as effects buses for production. Pressing this
key displays the Aux Sends screen.
Rotate these knobs to adjust the
Send A/B/C/D:
»
Figure 4-11: Aux Sends menu screen.
is used for
Normal
inverts the phase of
inverts the
Inv Right
Invert
only. Press to the new
Take
again returns to the Chan-
©2008 Axia Audio — Rev. 3.0
level of the audio you'll be sending to any or all
of the four Aux Send buses.
Pre/Post Fader:
»
SoftKnobs toggles the activity state of that par-
ticular The state is indicated in the display
Send.
above.
*
sends the source assigned to the fader
On Pre
to the selected Aux Send bus prior to having
its gain adjusted by the fader (fixed level).
*
sends the source assigned to the fad-
On Post
er to the selected Aux Send bus after having
its gain adjusted by the fader (variable level).
*
sends no audio to the Aux Send bus.
Off
»
Pressing
Aux Sends
nel Options screen.
• Feed To Source Key
If the assigned source (i.e., a codec or phone hybrid)
has an associated backfeed or mix-minus, pressing this
key allows the board op to change the audio supplied
through the backfeed. This selection is normally pre-set
when a Source Profile is constructed (see Chapter Two,
"Configuring Inputs," for information on Source Profiles),
but can be modified on-the-fly.
Figure 4-12: Feed to Source menu screen.
Pushing any of the four
Send
again returns to the Chan-