Axia Element Installation & User Manual page 72

A Note About Source Sharing: Element's
source sharing protocol keeps sources from
being controlled by more than one console at a
time.
If an operator tries to assign a source that's
already in use on another console and has a
backfeed or logic control enabled, the ID box in
the Channel Options screen informs him that
he has "Listen Only" rights to the source (as
seen in the righthand box above) - no backfeed
will be sent from his console, and no machine
logic is tied to the fader's ON/OFF keys.
If the source is not in use anywhere else, the
operator is informed that they have "Full Con-
trol" of the source (as shown in the lefthand
box above), and backfeed and logic operate
normally.
: rotating this SoftKnob scrolls
» Select/Take
through the available sources. Push to take.
allows you to hear the highlighted
Preview
»
source through the Preview speakers without
haveing to "take" it. Press and hold to listen; re-
Figure 4-22: Source menu screen.
lease to end the preview.
»
Pressing the
Channel Options screen.
• EQ Controls
Press the
is highlighted to adjust three-band parametric equaliza-
tion for the selected audio source. When the
is displayed, a graphical representation of the equaliza-
tion curve is displayed as the controls are adjusted. The
screen also indicates the amount of cut/boost applied,
and the center frequency of each band.
»
Rotate the
the
Lo, Mid
Notice that the left and center SoftKnob labels
change to display
Mid Freq
Function
»
The leftmost SoftKnob is the
to adjust the amount of gain or cut applied to the
selected band.
* Note that when you adjust
Peak indicator next to the onscreen control
©2008 Axia Audio — Rev. 3.0
Soft Knob returns you to the
Exit
SoftKnob when the
Select
SoftKnob to highlight
Function/Exit
or band knobs shown onscreen.
Hi
Lo Gain/Lo Freq, Mid Gain/
and
Hi Gain/Hi Freq
knob.
Gain
Lo Gain
Figure 4-23: EQ menu screen.
box
EQ Curve
screen
EQ
as you rotate the
control; rotate
, the Shelf/