Table of Contents
Advertisement
Fig. 7-6: Module Update screen
•
The
Firmware Version
ware version that's loaded on each module.
At the bottom of the page, you'll see a lot of informa-
tion pertaining to the health of the Element's CANBus
communication network. This is for diagnostic purposes
only.
The Firmware Update Menu
From time to time, new module firmware may be-
come available from Axia. You may confirm the current
Module Firmware versions installed in your Element and
install new firmware by choosing this menu item.
To update Module Firmware, use the
buttons to install the module firmware
Upload Image
package obtained from Axia Support. Once a new soft-
ware image has been uploaded, the Firmware Update
screen will change to notify you which modules have
new firmware available.
Each module must be updated individually. To up-
date a module, simply click on its
Note that updating a module takes it offline
during the update process. While audio playing
through the module's faders will continue un-
interrupted, keep in mind that while updating
(usually about 10-15 seconds) you will not be
able to adjust gain or turn faders on or off on the
field displays the fader firm-
and
Browse
link.
Update
©2008 Axia Audio — Rev. 3.0
Fig. 7-7: Brightness Control screen
module being updated.
CAN Bus Information Manu
This screen shows statistics about CANBus commu-
nications between Element's CPU and control surface.
Brightness Control Menu
This menu offers several useful options for fine-tun-
ing your Element's various LED and LCD displays to
your studio's ambient lighting. All values are expressed
in percent.
•
LED Icon Brightness
of the Status Symbols / fader numbers on the Ele-
ment overbridge (the little windows just above the
source identifiers).
•
LED Text Display Brightness
the alphanumic displays that indicate what source is
loaded to each fader channel.
•
Round Button Brightness
of the interior LEDs that illuminate Element's
,
,
tions
PGM 1-4
Monitor
selection keys.
•
ON / OFF Button Brightness:
figure this one out on your own :^)
•
User Module LED Text Display Flash Off-State
If you have any SmartSwitch modules
Brightness:
or accessory panels installed, you can use this set-
lets you adjust the luminance
does the same for
adjusts the luminance
Op-
,
and other
Headphone
You can probably
Advertisement
Table of Contents
