Table of Contents
Advertisement
Enter your network's subnet
»
Subnet Mask:
mask value here, usually 255.255.255.0
Gateway IP Address:
»
stration of your Livewire network, you'll need a
network gateway. If you have one installed, enter
its IP Address value here.
»
Engine IP Address:
controls a unique Studio Engine. Enter the IP of
the controlled Engine here.
1st NTP Server IP Address:
»
NTP (Network Time Protocol) timekeeping to
synchronize time-of-day clocks across your fa-
cility. If you have an NTP server, enter its IP Ad-
dress here.
2nd NTP Server IP Address:
»
software supports redundant NTP servers. Enter
the IP Address of your backup server here.
Web Page User Password:
»
protect your Element's webserver connection by
entering a numeric password here.
Note: If you set a password for HTTP access,
you will not see your password displayed in this
field upon re-entering the IP Address book. This
is a security feature intended to prevent "over-
the-shoulder" password theft.
•
If you want to reverse changes you've made and haven't
saved, press the
Undo
•
Press
to immediately reboot the Element.
Reboot
•
Press
to save changes you've made.
Save
•
Press
to leave the IP Address Book.
Exit
Note: After making changes to any Element IP
address settings, you must reboot the console.
Use the "REBOOT" soft key to begin an immediate
reboot sequence.
Remember, you can even reboot Element while
on-the-air, since the audio mixing is not done in
the console but in the Studio Engine; your audio
will continue to play without interruption.
Setting IP using the Monitor+ 2-Fader Module
When Element has completed its start cycle
To enable remote admin-
Each Axia control surface
Element supports
Element v2.x
You can password-
knob to erase them.
©2008 Axia Audio — Rev. 3.0
(meter screen appears), find the numeric keypad at the
top right of the Monitor Module. Press and hold the *
,
&
keys simultaneously for five seconds
(star)
"7"
"4"
to enter the IP Address Book (Figure 1-12).
Figure 1-12: IP Address Book,
Monitor Module
To set the IP address, rotate the leftmost SoftKnob to
highlight the line titled "Element IP Address" and push
the knob to select that line. Now use the numeric pad to
enter the IP address. Press the leftmost SoftKey again
to "take" the new IP value. Repeat this process to set the
subnet mask value.
Continue down the screen and, in the same way, en-
ter the other fields' values as appropriate.
•
Rotate the
Select/Set
the list of available options. To select an option to
modify, push this knob. While modifying an options,
rotate the knob to change an option's value, and push
the knob to move to the next field. Available options
include:
Element IP Address:
»
gear must have its own unique IP Address. Set
the IP Address for each Element in this field.
SoftKnob to scroll through
Every piece of Livewire
Advertisement
Table of Contents
