Telos One-X-Six, Direct Interface And 1A2 Systems - Axia Element Installation & User Manual

ate control signals for hybrids when Phone is selected as
the source type.
The status display above the entry boxes show you
the GPIO status and are useful for troubleshooting.
Operation
Load the hybrid source onto a fader channel. If you
are using the GPIO to control the Hybrid functions for
the Telos One or Delta hybrids, pressing the fader chan-
nel button turns the Hybrid ON, and pressing the
ON
button turns the Hybrid OFF.

Telos ONE-x-Six, Direct Interface and 1A2 Systems

To use these legacy hybrids, audio must be connected
via Analog nodes. There is a special two-position con-
trol panel that can drop into Element to control ONE-
x-Six, Direct Interface Module or 1A2 phone systems.
This panel communicates directly to the phone systems
using a dedicated cable rather than via Ethernet. Line
Take and Drop functions cannot be controlled using
GPIO on these systems, so the control surfaces supplied
with the phone systems must be used to actuate these
commands.
Installation & Configuration
1. Install the control module and connect it to the phone
equipment.
2. Connect audio input, output, and Program-On-Hold
to an Analog node. Use the left channel inputs and
outputs for these mono signals.
3. Using the Analog node's Source configuration web
page, enter a text name and channel number for each
input. It might be convenient to include the telephone
number as part of the text name. Configure for "Fast
Stream" audio mode.
4. Using the audio node's Destination configuration
web page, select the same channel number for each
output as was used for the corresponding input. Se-
lect "To source" for the Type and configure for "Fast
Stream" audio mode.
5. Open the Element Sources & Profiles Configuration
web page. Choose Source Profiles, then Create New
Source Profile. In your new source profile, choose
the Primary Source that you entered in the audio
node's setup page. Give it an Element source name
and select "Phone" for source type. Set the default
input mode to Left.
Operation
Load the hybrid source(s) onto the fader channels.
Use the control surfaces directly connected to the phone
Off
system to select lines and place callers on the hybrids.
Faders will not be controlled by the hybrids via GPIO
and will need to be manually turned
needed.
©2008 Axia Audio — Rev. 3.0
and as
ON OFF