Table of Contents
Advertisement
server on which you wish the logs to be stored.
•
Syslog Severity Level Filter:
allows you to set the level at which the Syslog begins
storing system events.
Generates Syslog only if the sys-
Emergency:
»
tem is completely unable to operate.
Syslog contains only messages notifying
»
Alert:
you that immediate attention is needed for the
system to remain operative.
Syslog contains only messages about
Critical:
»
critical system errors.
Syslog contains only messages about
Warning:
»
errors that could cause the system to become un-
stable.
System is operating normally, but Sys-
Notice:
»
log contains messages about unusual events that
you should know about.
Logs all informational messag-
Informational:
»
es. This includes all routine events.
Captures all system activity for diagnos-
»
Debug:
tic use.
After making changes, click the
save them.
Application Interface Options Section
Tells the StudioEngine whether it is
•
Console Type:
interfacing with an Element or SmartSurface console.
Only needed for Element consoles running software
earlier than v2.0; Element v2.X and above automati-
cally selects the correct setting upon boot.
Fig. 8-5: Console ID screen
•
Controlling V-Mixer from Element: Enable
the ability to control VMix from the Ele-
Disable
ment.
•
Save V-Mixer settings to config:
This menu choice
Console ID Menu
IP address of the console that will interface with this
StudioEngine. Simply enter the IP address of the console
and click
System Menu
formation fields pertaining to your StudioEngine.
•
button to
Apply
•
or
Click the
•
Save
©2008 Axia Audio — Rev. 3.0
button to save VMix settings in the StudioEngine's
config file.
This screen is used during setup to specify the
.
Apply
This screen contains several software utilities and in-
The
section of the page pro-
System Status
vides information about the physical state of the
StudioEngine.
and
System Status
»
you as to the health of the StudioEngine and its
connection to the Axia network.
indicates how hard the Engine is
»
CPU Usage
working.
tells you the type of link with which
Link Speed
»
the Engine is connected to the local network
switch.
»
Network Usage In
bandwidth is being consumed on the Engine-to-
switch link.
monitors the temperature of the
Temperature
»
StudioEngine CPU. If the temperature exceeds
operating limits, a warning will appear on the
Engine's front-panel display.
and
»
Fan 1
Fan 2 Speed:
of the Engine's two internal cooling fans.
The
Configuration Management
make backups of and restore your Engine settings.
Use the
,
Browse
Backup
accomplish these actions. Use the
to reset all of your StudioEngine's settings to an "as-
shipped" state. This command will completely erase
any choices you have made and reset your Engine to
the way it came from the factory, so use with cau-
tion!
The
Command To Engine
inform
Network Status
and
show how much
Out
Monitors the fan speeds
section lets you
and
buttons to
Restore
button
Reset Cfg
section lets you
Re-
Advertisement
Table of Contents
