Installing The Shift Arm; Adjusting The Shift Pedal - Yamaha STAR XVS95CE 2DX1 2014 Service Manual

Table of Contents

INSTALLING THE SHIFT ARM

• Shift arm "1"

Shift arm bolt

16 Nm (1.6 m·kgf, 12 ft·lbf)

Align the "I" mark "a" in the shift shaft with the

punch mark "b" in the shift arm.

The shift pedal position is determined by the in-

stalled shift rod length.

• Installed shift rod length "a"

Incorrect → Adjust.

Installed shift rod length

93.7–97.7 mm (3.69–3.85 in)

• Installed shift rod length

a. Loosen both locknuts "1".

The shift rod locknut (shift pedal side) has

left-hand threads.

b. Turn the shift rod "2" in direction "a" or "b" to

obtain the correct shift rod length.

ENGINE REMOVAL

Make sure that the engaged thread length on

both ends of the shift rod is 4 ridges or more.

Direction "a"

Installed shift rod length is increased.

Direction "b"

Installed shift rod length is decreased.

c. Tighten the locknuts to specification.

7 Nm (0.7 m·kgf, 5.1 ft·lbf)

d. Make sure the installed shift rod length is

within specification.

Table of Contents