Installing The Crankshaft Assembly - Yamaha STAR XVS95CE 2DX1 2014 Service Manual

Table of Contents

Tighten the connecting rod bolts using the fol-

lowing procedure.

a. Tighten the connecting rod bolts to specifica-

tion with a torque wrench.

Connecting rod bolt (1st)

15 Nm (1.5 m·kgf, 11 ft·lbf)

b. Put a mark "1" on the corner of the connecting

rod bolt "2" and the connecting rod cap "3".

c. Tighten the connecting rod bolts further to

reach the specified angle 125–135°.

Connecting rod bolt (final)

Specified angle 125–135°

When a bolt is tightened more than the spec-

ified angle, do not loosen and then retighten

Replace the bolt with a new one and perform

the procedure again.

• Do not use a torque wrench to tighten the

bolt to the specified angle.

• Tighten the bolt until it is at the specified

INSTALLING THE CRANKSHAFT

• Crankshaft assembly

To avoid scratching the crankshaft and to

ease the installation procedure, lubricate

each bearing with engine oil.

Align the right connecting rod with the rear cylin-

der sleeve hole.

Chapters

Table of Contents