Assembling The Rear Wheel; Adjusting The Rear Wheel Static Balance; Installing The Rear Wheel (Rear Brake Disc) - Yamaha STAR XVS95CE 2DX1 2014 Service Manual

Rear wheel pulley self-locking
nut
95 Nm (9.5 m·kgf, 69 ft·lbf)
TIP
Tighten the self-locking nuts in stages and in a
crisscross pattern.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS22140

ASSEMBLING THE REAR WHEEL

1. Install:
• Wheel bearings New
• Oil seals New
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-13.
EAS22150
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel drive hub installed.
1. Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-13.
EAS28770
INSTALLING THE REAR WHEEL (REAR
BRAKE DISC)
1. Lubricate:
• Rear wheel axle
• Oil seal lips
Recommended lubricant
Lithium-soap-based grease
2. Install:
• Rear brake disc
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
4-21
Rear brake disc bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
LOCTITE®
TIP
• Apply locking agent (LOCTITE®) to the
threads of the brake disc bolts.
• Install the brake disc so that the chamfered
portions of the bolt holes "a" face away from
the hub.
• Tighten the brake disc bolts in stages and in a
crisscross pattern.
a
LT
3. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-41.
4. Install:
• Rear brake caliper bracket "1"
• Rear wheel axle
• Washer
• Rear wheel axle nut
TIP
• Make sure that the slot "a" in the rear brake cal-
iper bracket fits over the stopper "b" on the
swingarm.
• Temporarily tighten the wheel axle nut.
1
a
b
5. Adjust:
• Drive belt slack
Refer to "ADJUSTING THE DRIVE BELT
SLACK" on page 3-16.
REAR WHEEL