Yamaha STAR XVS95CE 2DX1 2014 Service Manual page 185

5. Install:
• Clutch lever pivot bolt "1"
• Clutch lever "2"
• Clutch cable
TIP
Fit the projection "a" on the bottom of the bolt
head into the slot "b" in the bolt hole in the clutch
lever.
2
b
6. Install:
• Left handlebar switch "1"
Left handlebar switch screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
TIP
Align the projection "a" on the left handlebar
switch with the hole "b" in the handlebar.
1
a
7. Install:
• Handlebar grip "1"
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
1
a
1
a
1
b
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
4-50
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be less than 3 mm (0.12 in) of
clearance "a" between the handlebar grip and
left handlebar switch.
1
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
8. Install:
• Throttle cables "1"
(to the right handlebar switch "2")
Throttle cable bracket screw
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
1
9. Install:
• Right handlebar switch "1"
Right handlebar switch screw
3.5 Nm (0.35 m·kgf, 2.5 ft·lbf)
TIP
Align the projection "a" on the right handlebar
switch with the hole "b" in the handlebar.
HANDLEBAR
a
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
1
2