Removing The Drive Belt And Drive Pulley; Checking The Drive Belt; Installing The Drive Belt And Drive Pulley - Yamaha STAR XVS95CE 2DX1 2014 Service Manual

EAS23520
REMOVING THE DRIVE BELT AND DRIVE
PULLEY
1. Straighten the drive pulley nut ribs "a".
a
2. Loosen:
• Drive pulley nut
TIP
When loosening the drive pulley nut, press down
on the brake pedal so the drive pulley does not
move.
3. Remove:
• Drive belt
TIP
Push the rear wheel forward and remove the
drive belt from the rear wheel pulley. Refer to
"ADJUSTING THE DRIVE BELT SLACK" on
page 3-16.
EAS23530

CHECKING THE DRIVE BELT

1. Clean:
• Drive belt
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Wipe the drive belt with a clean cloth.
b. Put the drive belt in a mixture of mild deter-
gent and water. Then, remove any dirt from
the drive belt.
c. Remove the drive belt from the mixture and
rinse it off with clean water. Then, let the drive
belt thoroughly dry.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
2. Check:
• Drive belt
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
4-71
ECA1TP1030
NOTICE
• To protect the drive belt from damage, han-
dle it with care.
• The drive belt can not be bent smaller than
125 mm (4.92 in) "a".
• The removed drive belt can not be twisted
inside out.
3. Check:
• Drive pulley
• Rear wheel pulley
Bent teeth → Replace the drive belt and pul-
leys as a set.
EAS23540
INSTALLING THE DRIVE BELT AND DRIVE
PULLEY
1. Install:
• Drive belt
ECA1TP1031
NOTICE
Align the mark of the drive belt with the
progress direction "A".
Do not twist the drive belt when installing it.
A
2. Install:
• Washer
• Drive pulley nut New
TIP
Install the washer with its "OUT" mark facing out-
ward.
3. Tighten:
• Drive pulley nut
BELT DRIVE